villaarchitects.blogg.se - Fisher price monkey bouncer seat pink

#FISHER PRICE MONKEY BOUNCER SEAT PINK FREE#

Check your local authority for recycling advice and facilities. This symbol indicates that this product shall not be treated as household waste. Protect the environment by not disposing of this product or any batteries with household waste. If removable, rechargeable batteries are used, they are only to be charged under adult supervision.Remove rechargeable batteries from the product before charging.Do not charge non-rechargeable batteries.Use only batteries of the same or equivalent type as recommended.Never short-circuit the battery terminals.The batteries inside may explode or leak. Always remove exhausted batteries from the product. Remove batteries during long periods of non-use.Insert batteries as indicated inside the battery compartment.Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc), or rechargeable.In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. Slide the power switch off and then back on. If this product begins to operate erratically, you may need to reset the electronics.Fasten the pad straps on the back of the pad around the soothing unit.Pull and fit the pad seat bottom pocket around the soothing unit and footrest.

Replace the battery compartment door and tighten the screw.

Insert three C (LR14) alkaline batteries into the battery compartment.Loosen the screw in the battery compartment door.Remove the pad bottom pocket from the footrest C.Pull to remove the pad from around the tabs and the soothing unit B.Unfasten the pad straps on the back of the pad around the soothing unit A.Remove and properly dispose of the batteries and replace them with three new C (LR14) alkaline batteries. IMPORTANT! Low battery power causes this product to operate erratically: no vibrations and the product may not turn off.

#FISHER PRICE MONKEY BOUNCER SEAT PINK FREE#

Pull the anchored end of the restraint belt to shorten the free end of the restraint belt B. Enlarge the loop by pulling on the end of the loop toward the buckle.

Feed the free end of the restraint belt up through the buckle to form a loop A.

Pull the free end of the restraint belt B.

Feed the anchored end of the restraint belt up through the buckle to form a loop A.

Do not use accessories or replacement parts other than those approved by the manufacturer. Do not use this infant bouncer if it is damaged or broken. IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts, or sharp edges. This product is not intended to replace a crib or bassinet for prolonged periods of sleep.

STOP using bouncer when baby starts trying to sit up or has reached 20 lb (9 kg), whichever comes first.

Adjust to fit snugly, even if baby falls asleep.

NEVER use it on a bed, sofa, cushion, or another soft surface.

Suffocation Hazard: Babies have suffocated when bouncers tipped over on soft surfaces.

NEVER lift or carry a baby in the bouncer.

Adjust to fit snugly, even if baby falls asleep. WARNING Fall Hazard: Babies have suffered skull fractures falling while in and from bouncers.

Product features and decorations may vary from photographs.

Use from birth until baby starts trying to sit up or has reached 20 lb (9 kg), whichever comes first.

Requires three C (LR14) alkaline batteries (not included) for soothing unit operation.

Tools needed for assembly: Phillips screwdriver (not included).Īssembly instructions on the backside of this sheet. IMPORTANT! Read all instructions before use of the infant bouncer seat.

Press the volume buttons to adjust the volume level.

Press the music or sound effects button to play sounds.

Press the vibration button to turn vibrations on.